Tilbud

mBot Ranger Add-on Pack Laser Sword

300,00 DKK  Ekskl. moms 175,00 DKK  Ekskl. moms

Med denne ekstrapakke kan du forvandle din mBot Ranger til et lyssværd.

Præcist ligesom du kan programmere din Ranger, kan du også programmere dit lyssværd, så det kan lyse i forskellige farver og med forskellige effekter. Du kan vælge en af de traditionelle jedi-farver, eller du kan programmere dit lyssværd, så det f.eks. er regnbuefarvet eller lyser med en effekt som aurora borealis.

Programmeres via Arduino eller det medfølgende mBlock-software, som er baseret på Scratch 2.0, så både nybegyndere og mere erfarne programmører kan følge med.

Kræver mBot Ranger. Sælges separat.

mBot Ranger add-on pack Laser Sword

mBlock case programs

We provide mBot Ranger Laser Sword add-on pack with more than one mBlock case program. Introductions and download links of each case program are as below.

Click here to download.

  • Varying-color Charge Sword

Introduction:

When the finger gets close to “sensor 2” at the line follower sensor, the Laser Sword enters into “Charge State” and LED luminance increases. When LED luminance reaches to the maximum extent, the laser sword enters “Supercharged State”, the on-board LEDs flash and an “alarm” sounds.

  • Rainbow Sword

Introduction: When the Laser Sword is enabled, the on-board LEDs and LEDs at the RGB LED strip will light up one by one, producing a “rainbow” effect. When “sensor 1” and “sensor 2” at the line follower sensor are touched at the same time, the on-board LEDs and LEDs at the RGB LED strip will go out one by one until all LEDs go out. When “sensor 1” or “sensor 2” is not touched, the on-board LEDs and LEDs at the RGB LED strip will light up one by one, thus producing a “rainbow” effect again.

  • Sound Control Lamp

Introduction: When a sound of certain loudness is detected by the on-board sound sensor in the dark, the RGB LED strip will light up. The strip will go out after a while.

Instruction: The Laser Sword may be hung on the wall to act as a Sound Control Lamp.

  • Optical Control Lamp

Introduction: When the ambient luminance is below a certain value, the Laser Sword will light up. The darker the surrounding is, the brighter the RGB LED strip will be.

  • Breathing Sword

Introduction: When the Laser Sword lies flat, the LEDs will repeat lighting up and going out in a rhythmic way, just like “breathing”

  • Auroral Sword

Introduction: The Auroral Sword can be put into service when it is enabled, without any other operation. After it is enabled, the RGB LED strip will present a flow condition, just like the aurora.

  • Light Saber

Introduction: When the Light Saber is enabled, the music sounds and LED color changes several times.

The LEDs will go out one by one when the Laser Saber is put down and will light up when the Laser Sword is raised.

When “sensor 1” and “sensor 2” at the line patrolling module are touched at the same time, LED color changes.

Yderligere information

Vægt900 g

Du kunne også være interesseret i...

  • Tilbud
  • Tilbud

    Robot Gripper

    316,00 DKK  Ekskl. moms 199,20 DKK  Ekskl. moms